Identifying a possible water heater problem? You will want to go throughout your home, testing the hot water components to see whether or not your cool shower was an isolated incident or prevails throughout the entire home. If you are not getting any hot water, your water heater is the most likely culprit.
Initially, check the temperature setting on your hot water heater. If all is well, the next thing to consider is whether a fuse has been blown or tripped if you rely on electricity to heat your water. A fuse can be easily changed Visit this site . If you have gas, check to see if the pilot light went out. If it is, you can easily relight it, following the directions in the producers guide.
If repairing the temperature setup, fuse or pilot light does not fix your issue, chances are you could have a variety of other problems such as a malfunctioning thermocouple, flue obstructions, sediment buildup on the heating element, or even a malfunctioning temperature control.
When it is an isolated shower issue? If the other fixtures in your home produce hot water and stays hot for a length of time, your shower is an isolated issue. There are a lot of issues why your shower loses hot water. If you have old galvanized steel pipelines, they could be worn away and need replacing. Likewise, you should check the shut-off valve for the hot water to your shower. If it is closed or partially closed, open it and test the shower for hot water. However, if you only receive hot water or start getting cool water, you could have a shower valve issue.
Identifying a shower valve issue. Occasionally, shower valves become worn down with time, the rubber parts breaking down or swelling with age. When this takes place, the rubber parts shut out the path for streaming water. This clog typically happens with the shower valves as heat makes the rubber swell. In some cases, the rubber parts disintegrate and take a trip to the hot water valve to the shower, producing an obstruction. If you feel positive about taking apart the valve, you can clear out the faulty pieces in the hot water valve then change the rubber in the shower valve. Bear in mind that the majority of shower valves are located inside the wall and could only be accessible by an unknown panel in a closet in the next room or a cabinet in the bathroom.
If you are in the least bit hesitant about replacing a blown fuse, relighting a pilot light, replacing a hot water heater part or clearing an obstruction from the shower valve, it is most effective to talk to a plumbing professional. Exactly what is better? Paying for a plumbing contractor to fix it right the first time or waste money by causing even worse plumbing problems and wind up paying more for a plumbing contractors time?